1, servo motor oil and water conservation
    A: servo motor can be used in will be affected by water or oil lets hit the place, but it is not all waterproof or anti-oil. Therefore, the servo motor should not be placed or used in water or oil intrusion environment.
    B: If the servo motor connected to a reduction gear, use the servo motor fuel should be sealed to prevent the reduction gear oil into the servo motor
    C: servo motor cable should not submerged in oil or water.
    2, servo motor cable to reduce stress
     A: to ensure that cables are not due to external bending under the weight of its own force or torque, or the vertical loads, especially in the cable outlet or junction.
     B: In the case of servo motor movement, should be cable (that is configured with the motor Flanagan) firmly fixed to a stationary part of the (relative motor), and should be fitted with an additional cable supports inside the cable to extend the It is, so that bending stresses can be minimized.
     C: cable bend radius be as large as possible.
    3, servo motors to allow the shaft load
    A: to ensure that the installation and operation of the servo motor shaft, when added to the radial and axial load control in each model within the specified value.
    B: When installing a rigid coupling to be cautious, especially the excessive bending load may lead to shaft and bearing damage or wear and tear
    C: best to use flexible coupling, so that the radial load below the allowable value, this material is designed for high mechanical strength of the servo motor design.
    D: on allowing the axle load, please refer to "allow the axle load table" (with manual).
    4, servo motors Installation
    A: In the installation / removal component coupled to the servo motor shaft, do not beat with a hammer shaft directly. (Hammer beating shaft directly, the other side of the servo motor shaft encoder to be knocked worse)
    B: tried to get shaft alignment to the best state (for good may lead to vibration or bearing damage).